1- Switch on the rooter:” JuergenWalter” then connect you PC to
“JuergenWalter” WLAN
2- Go to the file where the MQTT file
1880 is saved: Dieser PC>Lokaler Datentraeger (C:)
>swimmingpixelhub>RotatingSQwimmingPixel-master
3- select
1880 thenClick on the file browser and right CMD then press enter
4- the cmd file will be opened then right in the first line:
node-red –u . –p 1880
PS: respect the spaces in the cmd command
5- open the internet browser and write: Localhost:1880
You
will find the MQTT program of the illumination and the motion
control
6- Open another browser window and right:
Localhost:1880/ui
You will find the user interface
7-
connect the battery cable of the car to its dedicated ESP32
8- connect the downside battery cable to the illumination
microcontroller
9- wait few seconds then check the
microcontroller screen: you should find “Connection OK” message
10- try to use the user interface to change the motion and the
illumination
PS: If you want to use simultaneously a second PC of
control just connect it to the same WLAN and open the user interface
from: localhost:1880/ui |
